2 untagged packet classifier mapping – CANOGA PERKINS 9145ELB NID Software Version 4.01 User Manual

Page 106

Advertising
background image

9145ELB NID Software User’s Manual

CoS Configuration

CoS Queues Configuration

96

NOTE: Mapping a queue on the User Port in C-VID mode is configured from the EVC configura-
tion menu. See “Viewing or Modifying the C-VLAN List” on page 118.

9.3.2 Untagged Packet Classifier Mapping

Untagged packet classifier mapping is supported on User Ports only. There are three
classification modes for untagged packets: IP Precedence, DSCP, and AFEF.

1. To configure queue mapping for untagged packets, from the Class of Service Queue

Configuration screen (Figure 9-4), type 2 and press Enter. The User Port Untagged
Packet Classifier Configuration screen opens (Figure 9-8).

Figure 9-8 User Port Untagged Packet Classifier Configuration screen

2. To select a classification mode for the User side, type 1 and press Enter. Press the Space

bar to select IP Precedence, None, DSCP, or AFEF and press Enter.

3. To assign a default queue for unclassified frames, type 2 and press Enter. Press the

Space bar to select LLQ, Q3, Q2, or Q1 and press Enter. Unclassified frames are all
untagged packets that do not have an IPv4 header (such as IPv6, L2CP, IPX). When
classification mode is set to None, all untagged frames are sent to this default queue.
Only a queue that is enabled can be selected. To enable or disable a queue, see “Queues
Configuration on Network Ports” on page 101
.

4. To set classifier mapping, type 3 and press Enter.

If you selected IP Precedence in step 2, Figure 9-9 opens. See the section “IP
Precedence Mode” on page 97
.

If you selected DSCP mode in step 2, Figure 9-10 opens. See the section “Differ-
entiated Service Code Point (DSCP) Mode” on page 97
.

Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
-------------------- USER PORT UNTAGGED PACKET CLASSIFIER CONFIGURATION --------

1) Classification Mode IP Precedence
2) Default Queue for Unclassified Frames Q1

3) Set classifier mapping

Select [1-3]:

------------------------------------Messages-----------------------------------

Advertising