CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 24)

9145ELB NID Software User’s Manual System Configuration
IP/SNMP Agent Configuration
14
messages. If there is no reply from the CE, the Service Provider will know instantaneously that
there is a fault in the connectivity between the two network elements.
3.1 IP/SNMP Agent Configuration
The IP/SNMP Agent Configuration screen (Figure 3-4) configures the Management IP, Test IP,
and Auxiliary IP settings, and is used to add, edit, or delete Host Table and Trap Table entries.
The Management IP, Test IP, and Auxiliary IP Addresses are used for managing and conducting
testing on a TCP/IP network.
Figure 3-4 IP/SNMP Agent Configuration screen
3.1.1 Management IP Configuration
On the IP/SNMP Agent Configuration screen (Figure 3-4), type 1 and press Enter. The
Management IP Configuration screen (Figure 3-5) opens.
Use this screen to configure the Management IP of the 9145ELB, including the subnet mask,
gateway, and management VLAN, and to configure which ports can be used for management
access. See your network administrator for information and help with determining the appropriate
parameters.
1. Manager IP Address Sets the 9145ELB Manager IP Address.
Subnet Mask Sets the 9145ELB Manager IP Subnet Mask.
Default Gateway Sets the IP Address of the Default Gateway.
2. Manager Port Used to select the port(s) to allow Management Communication access.
Options are: Network Port, MGMT UTP Port, and Disabled.
3. Manager VLAN Tagging Configures the interface to the Manager to be untagged,
single-tagged, double-tagged, or triple-tagged. The options are:
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
-------------------------------IP/SNMP AGENT CONFIGURATION---------------------
1) Management IP Configuration
2) Auxiliary IP Configuration
3) Host Table
4) Trap Table
Select [1-4]
------------------------------------Messages-----------------------------------