CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 26)

9145ELB NID Software User’s Manual System Configuration
IP/SNMP Agent Configuration
16
Figure 3-5 Management IP Configuration screen
7. Test IP Address Sets the IP Address for optional test features.
Test Subnet Mask Sets the Subnet Mask for optional test features.
8. Test Port Used to select which port(s) allow access to the Test IP address.
• If the 10G2 port is configured as a Network Port, then options are User1 Port Only
through User16 Port Only, 10G2 Port Only, and No Ports Allowed.
• If the 10G2 port is configured as a User Port, then options are User1 Port Only
through User8 Port Only, 10G2 Port Only, and No Ports Allowed.
9. Telnet Security Enables or disables checking if the host initiating the Telnet session is
listed in the host table. If Telnet Security is enabled the host must be included as part of
the host table. Default is disabled, which allows access from all hosts.
10. Reply to Broadcast Ping Enables or disables the 9145ELB reply to ICMP packets with
a broadcast IP Host Address in the Manager IP subnet. Broadcast Ping replies are an
ICMP packet and are rate limited to 100pps. Default is disabled.
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-B83-M-0 V04.01 10:55:13
---------------------------MANAGEMENT IP CONFIGURATION-------------------------
In-band Manager MAC Address 00 40 2A 04 12 D0
Manager MAC Address (MGMT UTP) 00 40 2A 04 12 D2
Manager Port Status UP
1) Manager IP Address 192.168.092.032
Subnet Mask 255.255.255.000
Default Gateway 192.168.092.001
2) Manager Port MGMT UTP Port
3) Manager VLAN Tagging Untagged
4) Manager C-VLAN ID 0
5) Manager T-VLAN ID 0
6) Manager S-VLAN ID 0
7) Test IP Address 000.000.000.000
Test Subnet Mask 255.255.255.000
8) Test Port User1 Port only
9) Telnet Security Disabled
10) Reply to Broadcast Ping Disabled
Select [1-10]:
------------------------------------Messages-----------------------------------