CANOGA PERKINS 9145ELB NID Software Version 4.01 - Manual (Page 30)

9145ELB NID Software User’s Manual System Configuration
IP/SNMP Agent Configuration
20
3. To change Telnet Access, type 1 and press Enter. Press the Space bar to select Telnet
and SSH, Telnet Only, SSH Only, or None.
4. To change FTP access, type 2 and press Enter. Press the Space bar to select FTP and
SFTP, FTP Only, SFTP Only, or None. Press Enter to select the parameter.
5. To change SNMP Access parameters, type 3 and press Enter. Press the Space bar to
select Read, Write, or None. Press Enter to select the parameter.
6. To change the SNMP Protocol parameters, type 4 and press Enter. Press the Space bar:
V1/V2c/V3, V1/V2c, or V3 using the Space Bar. Press Enter to select the parameter.
Figure 3-8 Edit Host Access screen
7. To change V1/V2c Read Community, type 5 and press Enter. Type the desired V1/V2c
Read Community and press Enter.
8. To change the V1/V2c Write Community, type 6 and press Enter. Type the desired V1/
V2c Write Community and press Enter.
9. To change the V1/V2c Access Level, type 7 and press Enter. Press the Space bar to
select Operator, Supervisor, or Observer. Press Enter to select the parameter.
10. Press Esc to return to the Host Access Table screen.
NOTE: SNMP V3 security parameters are configured per user account on the Edit User Account
screen. From the System Configuration screen type 4 and press Enter to open the Account Con-
figuration screen, then type E to edit an account.
Canoga Perkins Corp. Ethernet 1G/10G Network Interface Device 29-AUG-2011
9145ELB-971-4-0 V04.01 10:55:13
----------------------------------EDIT HOST ACCESS-----------------------------
Managing Host IP :
IP Mask Size :
1. Telnet Access :
2. FTP Access :
3. SNMP Access :
4. SNMP Protocol :
5. V1/V2c Read Community :
6. V1/V2c Write Community :
7. V1/V2c Access Level :
Enter Managing Host IP address
------------------------------------Messages-----------------------------------