Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 15)

15
Static and Kinematic Surveys-2.0.0en
Taking Static / Rapid-Static measurements
6
7
8
9
13
Step 3 (optional): Format your memory card
You are now in the Utilities \ Format
Memory Module panel:
If you want to format the PC-card just
press F1 CONT to format the card. If
you want to format the internal
memory press ENTER. A listbox
opens which allows you to select the
internal memory.
Before you start logging data you
may want to (re-)format your PC-card
or your internal memory.
This step is only necessary if
a completely new PC-card is
used or all existing data
should be deleted !
Press 4 on the terminal or use the
cursor down key to highlight the line
"4 Utilities", then press ENTER;
alternatively press F1 CONT.
(If only lines 1 to 3 are visible at this
stage press F4 SHOW first).
Then press 2 to get access to the
"Format Memory Module" panel, or
alternatively use the cursor key to
navigate to "2 Format Memory Mod-
ule" and press ENTER; again
alternatively press F1 CONT.