Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 16)

16
Static and Kinematic Surveys-2.0.0en
Taking Static / Rapid-Static measurements
6
7
8
9
3
Step 3 (optional): Format your memory card, continued
Once the formatting of the card is
completed the MAIN\ panel will
reappear.
Step 4: Begin a survey
Enter the Survey operation by either
pressing 1 in the Main\ panel or by
first navigating to "1 Survey" via
cursor keys and then pressing
ENTER or F1 CONT.
The following panel will appear:
Some basic decisions have to be
made in this panel:
Which configuration set should be
activated, in which job the raw data
should be stored and which antenna
setup should be used.
Use the cursor key to highlight
Internal, then press ENTER. Then
press F1 CONT in order to start the
formatting process of the internal
memory.
Warning
By activating the format
command all data will be lost!
Make sure that all important
data which resides on the
PC-card is properly backed-
up before reformatting the
card. If you want to reformat
the internal memory make
sure that all important data is
first transferred to the PC.
If you realize that you do not want to
format the memory device, simply
press ESC instead of F1 CONT. This
keystroke brings you always a step
back into the previous panel without
execution of any command.