Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 40)

40
Static and Kinematic Surveys-2.0.0en Kinematic and Stop & Go surveying
6
7
8
9
3
3
9
3
4
7
Carrying out Kinematic and Stop & Go measurements, contd.
Press F1 CONT to proceed.
Step 3:
Taking kinematic and Stop & Go
measurements
After F1 CONT has been pressed the
survey panel appears:
Start with a static point measure-
ment. Measure a point for a few
minutes. Make sure you keep the
antenna steady:
• Use a tripod on the starting point
• Use supporting legs (quickstand)
in case the GPS antenna is
mounted on a rangepole
• Hold the rangepole against a
fencepole or another stable object
Take the measurements of the
starting point by pressing F1 OCUPY
to start logging static observations,
followed by pressing F1 STOP after a
few minutes and F1 STORE to store
the point related information like
Point Id and Antenna Height.
• Select a job of your choice.
• Select the antenna setup you use,
most likely AT502 Pole (or AT501
Pole in case a SR510 sensor is
used):