Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 21)

21
Static and Kinematic Surveys-2.0.0en
Taking Static / Rapid-Static measurements
6
7
8
9
13
Step 5: Logging raw data, continued
The STORE key has become active,
and you have still the chance to
check and correct entered point id
and antenna height.
Conclude the survey sequence by
again pressing F1 STORE.
After pressing the STORE key all
related information will be stored in
the currently used job (point id,
antenna heights, etc.)
Step 6: Ending a survey
Once sufficient amount of raw data
has been collected the survey of the
point can be completed by pressing
F1 STOP.
The screen is altered as follows:
You can now quit the survey operation
panel by pressing SHIFT F6 QUIT.
This brings you back to the main
menu.
Pressing SHIFT F6 will
always allow you to terminate
the survey operation, even
during a site occupation. In
this case you will loose all
data collected since pressing
OCUPY.
As soon as you are back to the main
menu the PC-card may be removed.
This is indicated by the PC-card icon
in the status line which contains an
arrow: