Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 23)

23
Static and Kinematic Surveys-2.0.0en Exploring the sensor status during operation
6
7
8
9
13
23
Exploring the sensor status during operation
It is now very simple to navigate
further through all available status
screens. Either use the cursor up /
cursor down key to highlight the
various options, then press either F1
CONT or ENTER. A quicker way is to
press numbers 1 , 2, 3 or 4 to get
direct access to the next level of
status menus.
A detailed description of all status
screens can be found in the
Technical Reference Manual.
This short guideline will only
concentrate on the screens which are
important for Static and Rapid-Static
measurements.
The terminal gives direct access to
all relevant status information via a
dedicated STATUS key. This key -
located in the center of the terminal -
is accessible at any time and
regardless of the current system
operation. By pressing STATUS the
following menu appears: