Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 4)

4
Static and Kinematic Surveys-2.0.0en Contents
Contents
Introduction ................................................... 6
Equipment checklist for Static and Rapid-
Static measurements using System 500 ..... 7
Setting up System 500 for a static survey ... 8
Using the TR500 terminal ............................. 9
Menus ......................................................................... 9
Entering information ....................................................10
Listboxes .................................................................... 11
Hardkeys ....................................................................12
Taking Static / Rapid-Static measurements13
Step 1: Power on ........................................................13
Step 2: Study the icons ...............................................13
Step 3 (optional): Format your memory card .................15
Step 4: Begin a survey ................................................16
Step 5: Logging raw data .............................................19
Step 6: Ending a survey ..............................................21
Suggested exercise: Measure a very short baseline .....22
Exploring the sensor status during operation
...................................................................... 23
Satellite status............................................................24
Stop & Go indicator .....................................................25
Battery and memory status .........................................26
Display current navigated position ................................27
Suggested exercise: Get familiar with system status ....28
Changing the system configuration
parameters ................................................... 29
Turning on the illumination of the terminal .....................30
Changing the observation rate ......................................30
Setting local time zone................................................31
Changing distance units from meter to feet ...................32
Creating new configuration sets ................ 33
Programming Wake-up Sessions .............. 34