Leica Geosystems GPS System 500 - Getting Started with Static and Kinematic Surveys - Manual (Page 17)

17
Static and Kinematic Surveys-2.0.0en
Taking Static / Rapid-Static measurements
6
7
8
9
13
Step 4: Begin a survey, continued
Now use the cursor up or cursor
down key on the terminal to highlight
the PP_STAT line. Then press
ENTER or F1 CONT.
Jobs are used to organize and
structure the data you collect in the
field. Jobs can comprise an unlimited
number of points together with all
related information (raw measure-
ments, codes, point annotation, etc.).
It is suggested to create a new job
whenever you start a new project.
Upon formatting the memory device
(i.e. PC-card or internal memory) a
default job is automatically created.
You can either use this job straight
away or you can create your own job
by doing the following:
Move the cursor up or cursor down
key of the terminal into the input field
for jobs. Then press ENTER. The
following lisbox will appear:
Then a list box showing all available
sets becomes available:
A Configuration Set (Config Set) is a
collection of certain sensor
parameters needed to perform a
certain operation, like data recording
rates, point id templates, data
formats, antenna types, coding
methods, etc.
Several default configuration sets
exist which cover standard survey
scenarios. How to create new
configuration sets is described in a
later chapter as well as in the
Technical Reference Manual.
For static survey you should select
the PP_STAT configuration set. You
can make this selection either by
using the cursor left key to toggle
between all available configuration
sets until PP_STAT appears or you
can highlight the input field and press
ENTER.