Panasonic Panafax UF-127M - Manual (Page 27)

FAX PARAMETERS
Your machine has a variety of adjustable Fax Parameters. These Fax Parameters are preset for you
in standard settings (see Fax Parameter Table on page 25). Usually you do not need to change the
settings. However, you may wish to change some of them to suit your own circumstances. Once
you reset the standard setting, it will be effective until you change it again. Some of the settings,
such as Resolution or Contrast, can also be changed temporarily by pressing the particular key on
the Control Panel before a transmission starts. After the transmission ends, these parameters return
to their preset settings.
Changing Fax Parameter Settings (Header Print Position, Dialing Method, etc.)
and
___
n
Enter a Fax Parameter number (always two
digits) from the Parameter table.
Ex: Eirrifor Resolution.
0 1
m 1
'—Blinking
The number inside the brackets is the standard setting and the number blinking
on the right is the current setting.
Enter the new setting.
Ex: [2]
0 1 [1] 2
Blinking
4
To store the new setting,
<t> START
L
Return to Step 2 to change the next parameter,
or return to standby by pressing [STOP I.
1 5 - 1 0 - 1 9 9 1 1 5 : 0 0
NOT€
1. if you entered a wrong number in Step 3, reenter the correct number over it.
2, If necessary, print out a Fax Parameter List to confirm the current setting before changing. To print it out. see page 57,
24