Panasonic Panafax UF-127M - Manual (Page 75)

в. TROUBLESHOOTING WITH A TELEPHONE ANSWERING
MACHINE (TAM) CONNECTED
AUTO MODE
Problem
1) Cannot utilize the remote turn-on feature of
the telephone answering machine. The fax
machine always answers after the 8th ring.
2) Fax machine will not start up when the TAM
is set to give only an outgoing message
{OGM).
3) A beep sound is recorded as Incoming
Message (ICM).
4) Fax machine starts up in the middle of the
Outgoing Message (OGM).
5) Cannot record any Incoming Message (ICM).
The fax machine always starts up at the end
of the OGM and before the tape advances to
the end of last ICM.
Solution
This feature is not compatible. The fax machine
is designed to answer after 8 rings if the TAM
does not answer.
TAM with outgoing message (OGM) only is not
compatible. The fax machine will work with a TAM
that will record Incoming Message (ICM).
Speak a little slower between each word while
recording OGM.
Make sure the OGM does not have silent pause
longer than 3 seconds.
If your TAM uses a single cassette tape to give
OGM and to record ICM, set Silent Detection
Function to “OFF” (see pages 24 - 25).
6) Cannot receive from machine that does not
send a beep tone (CNG) after dialing.
7) Cannot retrieve message from the answering
machine remotely, the fax machine always
starts up after the command code is inputted.
Set Silent Detection Function to “ON” (see pages
24 - 25).
After the command code is inputted, press a digit
on the telephone keypad approx, every 2 seconds
until you start hearing your message. Select a
digit that does not correspond to any of the remote
functions of your Answering Machine. Refer to
your Answering Machine's Operation Guide.
FAX MODE
1) Fax machine will not start to receive with TAM
in auto-answer mode.
Increase the No. of ringing detection on the TAM.
70