Panasonic Panafax UF-127M - Manual (Page 34)

TRANSMISSION SETTINGS
You can temporarily change several settings, such as Resolution and Original (Contrast), before you
send a document. Choose the most appropriate settings for the transmission before or after you set
the document on the ADF. You can also change these settings during transmission, but the change
will not become effective until the machine starts transmitting the next page.
You can confirm whether each page was transmitted successfully or not by setting Verification Stamp
to “ON" (see pages 24-25). Verification Stamp is stamped at the bottom of each successfully
transmitted page with a small plnk®mark.
Resolution
Your machine is preset to Standard resolution, which is suitable for an ordinary document.
1 The current setting of Resolution is indicated by on the display.
1 5 - 1 0 - 1 9 9 1 1 5 : 0 0
r-J 1 >
STD FINE S-FiNE
If the document is very detailed, press I RESOLUTION I and select Fine resolution.
RESOLUTION
1 5 - 1 0 - 1 9 9 1 1 5 : 0 0
r-J I
STD FINE S-FlNE
If the document is extremely detailed, select S-FINE, which stands for Super Fine
resolution.
RESOLUTION
1 5 - 1 0 - 1 9 9 1 1 5 : 0 0
^ I
STD FINE S-FINE
To return to the Standard setting position, press I RESOLUTION i again.
After choosing the appropriate resolution setting, proceed to the next transmission
setting or begin dialing.
NOT€
1. If you set Fine or Super-Fine resolution, the document wilt take longer to send than with Standard resolution.
2. When transmission ends, the setting returns to the standard setting. If you frequently use a different setting from
the preset setting, change the standard setting (see Fax Parameters, pages 24 - 25).
3. To make a trial copy before sending, press | COPY I.
29