STIEBEL ELTRON SOL 25 PLUS - Manual (Page 18)

18 | SOL 25 PLUS WWW.STIEBEL-ELTRON-USA.COM
Step 03: Prepare to assemble the top left
corner.
Step 04: Slide M10 bolt into slot of profile
rail.
Step 05: Position the diagonal support such
that the M10 bolt protrudes through the hole
closest to the end.
Note 1: If assembling a 45° horizontal
mounting system, there is only one hole on
either end of the diagonal support.
Note 2: If assembling a mounting system
using the longer profile rails (p/n 185546)
the diagonal supports should not be fas-
tened to the ends of the profile rails, but
should be assembled such that the supports
are approximately 2’ from each side of the
profile rail and are therefore approximately
4 feet from each other.