STIEBEL ELTRON SOL 25 PLUS - Manual (Page 33)

WWW.STIEBEL-ELTRON-USA.COM SOL 25 PLUS | 33
EN
g
L
IS
h
Step 02: Place the profile rail upside down
as shown. The longer cutout surface
(approx. 1”) should be facing toward the
center of the rectangle and be parallel to
the ground. This is the surface on which the
back of the collector will rest.
Step 03: Slide one of the M10 bolts into the
slot of the profile rail as shown.
Step 04: Prepare to assemble the top left
corner of the rectangle. The end of the
support rail with the hole closer to the edge
is the top side of the rail.
Note: If assembling a mounting system
using the longer profile rails (p/n 185546)
the support rails should not be fastened
to the ends of the profile rails, but should
be assembled such that the supports are
approximately 2’ from each side of the
profile rail and are therefore approximately
4 feet from each other.