STIEBEL ELTRON SOL 25 PLUS - Manual (Page 50)

50 | SOL 25 PLUS WWW.STIEBEL-ELTRON-USA.COM
Step 06: Slide the threads of the bolt
through the hole in the top side of the of the
support rail.
Step 08: Displayed is the completed
rectangle (top view).
Step 07: Install the M10 serrated flange nut.
Repeat this procedure for the remaining
three corners of the rectangle, making sure
that the top sides of the profile rails are each
attached to the same profile rail.
Note 1: If assembling a horizontal tilt
mounting system, there is only one hole on
either end of the diagonal support.
Note 2: If assembling a mounting system
using the longer profile rails (p/n 185546)
the diagonal supports should not be
fastened to the ends of the profile rails, but
should be assembled such that the supports
are approximately 2’ from each side of the
profile rail and are therefore approximately
4 feet from each other.