FRITSCH PULVERISETTE 7 premium line - Manual (Page 102)

8.2.1 Removing the grinding chamber cover
1. Remove the 4 screws from the side of the housing using a screw-
driver.
2. Then, carefully tilt the grinding chamber cover to the right.
3. 3 connectors now need to be released.
4. After doing this, the cover can be lifted off completely and the
grinding chamber can be cleaned.
5. To fit the grinding chamber cover, proceed in the reverse order.
DANGER!
Do not allow any liquids to flow into the device.
Cleaning
- 102 -