FRITSCH PULVERISETTE 7 premium line - Manual (Page 84)

d socket head screws
When inserting the locking ring (11), make sure that the two holes are
positioned over the socket head screws (d).
The lid normally remains on the bowl (10).
If the lid (9) is on the measuring/transmission unit (8), release it by hand
before cleaning. The lid (9) and the bowl (10) can be cleaned under run-
ning water as described in Ä Chapter 8.1 ‘Grinding elements’
on page 101.
6.3.11.1 Cleaning the sensor and replacing the seal
The sensor (G) must not be subjected to any mechanical stress. It is per-
mitted to cleaning it with a wet cloth. The O-ring (5) can be replaced if
necessary.
Accessories
- 84 -