Kistler-Morse KM ultrawave - Manual (Page 13)

2. Drill the mounting holes.
3. Attach the junction box using hardware that will secure it firmly in place.
Note: Mounting hardware for the junction box is not supplied by Kistler-Morse.
Mounting controller
When mounting the controller, be sure there is enough clearance to open the front door completely. Removal and
insertion of the modular PCBs and wiring of the transducers and the PCBs are done through the front of the unit.
Do not mount the controller near high power equipment, contractors, SCR drives, 440 V lines, etc. The controller
enclosure dimensions are shown in Appendix E, Technical Drawings. Refer to Appendix A for environmental
specifications before mounting the unit.
Follow this procedure to mount the controller:
1. Hold the controller enclosure against the wall in the desired location and mark the positions of the
mounting holes. Place the controller in a safe place.
2. Drill the mounting holes in the wall.
3. Attach the controller to the wall using hardware that will secure it firmly in place.
Note: Mounting hardware for the controller is not supplied by Kistler-Morse.
9
97-1163-01 Rev. D
www.kistlermorse.com