Kistler-Morse KM ultrawave - Manual (Page 41)

The menu tree of the UltraWave Series controller is used to enter and view settings, set up, calibrate, and
troubleshoot for the system. There are nine submenus listed in the Main Menu:
• 10 Display: enter and view display settings
• 20 Calibration or Math Menu: calibrate the system
• 30 Relay Set Point: enter and view set point parameters
• 40 I-Output: enter and view current output parameters
• 50 Serial /PLC: enter and view serial port configurations
• 60 Transducer: configure transducer specific parameters (power, gain, etc.)
• 70 Range/Filters: configure min/max range and filters i.e. noise, Sentry™ DSP
• 90 Service Menu: turn channels on and off
reset parameters to default values
test the keyboard and non-volatile RAM
set up a user access code
Figures 10a - 10e show menu levels 1-3 for all parameters. These figures are used as a quick reference guide
to quickly find the function to be performed. For example, to change setpoint parameters, the figure shows how
this is done in the level 30 parameters.
Note: Some of the submenus are not shown in the menu tree in Figure 10a due to space constraints and will vary
depending on application.
Figure 10a: 10 Display
* Parameters may change for flow. See page 32.
37
97-1163-01 Rev. D
www.kistlermorse.com