Connecting a css 11503 dc power cord – Cisco 11500 Series User Manual
Page 84
Chapter 2 Cabling the CSS
Connecting the Power Cord
2-28
Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03
3.
Plug the power cord into a dedicated 3-wire grounding receptacle.
4.
To power on and boot the CSS, refer to Chapter 3,
.
Connecting a CSS 11503 DC Power Cord
Before you install a DC power cord, refer to Appendix A,
, for the
DC power supply.
Warning
The DC power supply cord requires at least a 14 AWG wire (maximum 10 AWG
wire). The CSS 11503 draws a maximum of 10 amps.
Warning
Use copper conductors only.
Warning
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.
Warning
Before performing the DC installation procedure, ensure that power is removed
from the DC circuit. To ensure that all power is off, locate the circuit breaker
that services the DC circuit and switch it off.
Warning
When you are installing or replacing the unit, the ground connection must
always be made first and disconnected last.