Table 3-1 – Cisco 11500 Series User Manual

Page 96

Advertising
background image

Chapter 3 Booting and Configuring the CSS

Booting the CSS for the First Time

3-4

Cisco 11500 Series Content Services Switch Hardware Installation Guide

78-13884-03

Table 3-1

defines the boot states and the Status LEDs blinking patterns.

If an error occurs during a test, the console displays an error message, increments
the detected error counter, and continues to the next test until it completes all of
the power-on self tests. For more information on errors and messages, refer to
Appendix C,

Troubleshooting

.

Table 3-1

Status LEDs Boot Definitions

State Sequence

LED Color

LED State

1.

Power up, flash scan, and power-on self test
occur.

Amber

Fast blink

Power-on self test detects an error.

Red

Solid

2.

The CSS 11501 or a module in the CSS 11503 or
CSS 11506 is off line and active.

Amber

Slow blink

3.

The CSS 1150 or a module in the CSS 11503 or
CSS 11506 module is on line and not active.

In the CSS 11506, a passive SCM LED remains
in this state and color.

Amber

Solid

4.

The CSS 11501 or a module in the CSS 11503 or
CSS 11506 is on line and active.

Green

Solid

The CSS 11501 or a module in the CSS 11503 or
CSS 11506 (except a Fast Ethernet Module)
fails.

If a Fast Ethernet Module fails in the CSS 11503
or CSS 11506, all of its Link and Duplex LEDs
blink simultaneously.

In the CSS 11503 or CSS 11506, when the
master SCM in slot 1 detects a module failure, its
Status LED is green and blinks slowly.

When the master SCM in slot 1 fails, the CSS
does not boot unless there is a passive SCM in
slot 2.

Red

Blinking

5.

Disk activity

Green

Variable
blinking

Advertising