Attaching and removing the battery pack, Attaching, Removing – Sharp VIEWCAM VL-NZ50U User Manual
Page 20: Preparation
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching and Removing
the Battery Pack
Attaching
Power switch
Make sure that the Power
switch is set to OFF.
Align the _ mark on the side of the
battery pack with the • mark on the
camcorder ((i)), and slide the battery
pack in the direction of the arrow
compietely untii it locks into piace ((
2
;.).
Removing
1
Make sure that the Power switch is set
to OFF.
2
Rotate the monitor section of the
camcorder (i ), then press the battery
release ( ? ). Slide the battery pack in
the direction of the arrow and take it out
(®).
Cautions:
• BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF. Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum.
• Remove the battery pack from the camcorder if
you will not use the
camcorder for
a long period
of time.
• Make sure that the battery pack is firmly
attached during operation. If it is not, the battery
pack may come off or camcorder operation may
fall because of the poor
contact
pressure.
• To prevent damage to the battery pack when
removing, be
sure to firmly hold the battery pack
while pressing the release.
• Use only SHARP model BT-L225 or BTL445
battery packs with this camcorder. Use of
other
batteries may create a risk of fire or explosion.