Sharp VIEWCAM VL-NZ50U - Manual (Page 55)

Using the Time Code
The time code shows the hour, minute and
second of recording, and the frame number
(1 frame = approx, 1/30 sec,). This Is automati­
cally recorded along v/ith the subject when you
are recording on the tape. You can display the
time code on the screen as an accurate
counter In both VCR and CAMERA modes.
Display format
TC.0.:.00.: .10,: ^a
Frame number*
Second
Minute
Hour
Displayed during still
playback.
1
> The example screens shown are for VCR mode.
During playback or camera recording,
press the MENU button until the menu
screen appears.
2
Press V or A on the operation button
to select ETC, then press the SET button.
3
Press V or A to select “TIME CODE”,
then press the SET button.
Press the MENU button to turn off the
menu screen.
• The time code appears when the on­
screen Indicators are turned on.
a
JCO; 5; 35.
AUDlOm
Time code
To turn off the time code
Select “DISP, OFF" In step 4 above.
Note:
• When the tape reaches an unrecorded section,
the time code returns to zero {TC0:00:00). Once
recorded, the time code cannot be changed.
Displaying the time code on a
TV during playback
1
In VCR mode, press the MENU button
until the menu screen appears.
2 Press V or A on the operation button
to select ETC, then press the SET button.
3
Press 7 or A to select “TC OUT”, then
press the SET button.
4
Press V or A to select “DISP. ON”, then
press the SET button.
ID ISP. ON TIME CODE
Press
7
or A to select “ON”, then press
the SET button.
TC OUT ION
5
Press the MENU button to turn oft the
menu screen.
42