GTCO SummaSketch FX - Users Guide - Manual (Page 10)

SummaSketch FX 10
4. At the configuration menu, choose Configure Digitizer. AutoCAD asks if you want a
new digitizer. If installing for the first time, type Y and then press ENTER. A list of
digitizer options appears on the screen. Choose ADI P386 digitizer and press ENTER.
5. Select the number corresponding to the tablet size and press ENTER.
6. Enter the appropriate number of buttons on your pointing device (stylus or cursor)
and select ENTER.
7. You are now asked to choose the serial port to which your tablet is connected. Type
COM1 or COM2 and press ENTER.
8. The configuration is now complete and you are now ready to use the
Summagraphics tablet with AutoCAD. Exit to the drawing editor and enter Y to save
changes.
Installing the Protected Mode Driver for AutoCAD Release 12
1. Copy the protected mode drivers from the Summagraphics Drivers/Utilities diskette
to the ACAD\DRV directory. Example: COPY A:\ADIDVR\DGPSUMMA.EXP
C:\ACAD\DRV
2. Start AutoCAD. The AutoCAD Drawing Editor appears on the screen.
3. Type CONFIG and press ENTER. A listing of the current configuration appears on the
screen. Select ENTER to proceed to the configuration menu.
4. At the configuration menu, choose Configure Digitizer. AutoCAD asks if you want a
new digitizer. If installing for the first time, type Y and press ENTER.
5. Select the number corresponding to the tablet size and press ENTER.
6. Enter the appropriate number of buttons on your pointing device (stylus or cursor)
and select ENTER.
7. You are now asked to choose the serial port to which your tablet is connected. Type
COM1 or COM2 and press ENTER.