GTCO SummaSketch FX - Users Guide - Manual (Page 8)

SummaSketch FX 8
utilities – MMRST (used with tablets configured for UIOF/Microgrid format) – clears
the tablet for a new configuration. (Note that you can also reset the tablet by
repowering it).
To change default tablet parameters.
Some applications will only support either the MM/SummaSketch format or the
UIOF/Microgrid format. For example, a tablet configured for MM/SummaSketch
format and wishes to use an application written for the UIOF/Microgrid format;
change the default tablet format from MM to UIOF. There are two utilities for
changing between MM and UIOF formats:
MM.COM – Utility sets the format of a SummaSketch tablet to MM/SummaSketch.
UIOF.COM – Utility sets the format of a SummaSketch tablet to UIOF/Microgrid.
7. SPECIAL NOTE FOR UIOF FORMAT USE
To use the tablet in UIOF/Microgrid mode, run the UIOF utility before starting the
application driver.
Chapter 2: Guidelines for Installing the Drivers/Utilities
The Drivers/Utilities Diskette
 ADIDVR – Contains the MM format and UIOF format drivers for AutoDesk®
applications (both real mode and protected mode versions)
 TABLTDVR – Contains the MM format and UIOF format versions of the
Summagraphics tablet driver/Microsoft® mouse emulator.
 WINDVR- Contains the MM format and UIOF format WinTab-complaint drivers for
Microsoft Windows.
 UTILITY – Contains the following utilities: MMRST, UIOFRST, MMTEST, MM, UIOF and
SEND.
Making Backups
Before installing any of the drivers or utilities, make a backup copy of the SummaSketch
Driver/Utilities diskette. Use only your copy and store the master in a safe place.