GTCO SummaSketch FX - Users Guide - Manual (Page 4)

SummaSketch FX 4
C. Replace the battery door. The cordless cursor is now ready for use with the
SummaSketch FX tablet. Proceed to step four of the installation instructions.
NOTE: The cordless cursor has a special energy saving feature designed to extend the life
of the batteries. After approximately 5-10 minutes of non-use, the cursor will automatically
shut itself off. To reactivate the cursor, simply press a button.
Using the Cursor Corded
To prepare either the four or sixteen button cursor for corded use:
A. Remove the battery door from the back of the cursor by using a small flathead
screwdriver.
B. Remove the batteries if the transducer was previously used cordless. Carefully
plug the four-pin connector of the cursor cable into the socket located in the
battery compartment. Please note do not force the connector into the socket.
The plug and socket are keyed and fit together in one direction only. If one way
does not work, try the other.
C. Insert the cursor cable into the groove at the bottom of the cursor making sure
the round bead is lying flat inside the battery compartment.
D. Replace the battery door.
E. Plug the cursor cable into the top right socket on the SummaSketch FX tablet.
The corded cursor is now ready for use with the SummaSketch FX tablet.
Proceed to step four of the installation instructions.
NOTE: Be certain to power down the tablet before plugging in a corded transducer. Do not
have the batteries and cable plugged into the transducer simultaneously. This could
damage the transducer and void the warranty.
Using the Stylus Cordless
To prepare the three-button pressure sensitive stylus for cordless use:
A. Hold the stylus with the thumb resting on the clip over the battery hatch. Press on
the back of the stylus until hearing a click. Using the other hand, pull the hatch off
the stylus.