GTCO SummaSketch FX - Users Guide - Manual (Page 33)

SummaSketch FX 33
If the tablet performs all of these tasks, then it is operating properly. If not, refer to
Appendix A: What to do if a Problem Arises in the back of this manual.
Exiting MMTEST
To exit MMTEST, type: <CTRL>X
Chapter 3: Changing Tablet Format (MM.COM, UIOF.COM and SEND.COM)
MM Tablet Configuration Utility
The MM Utility configures a tablet to MM/SummaSketch format.
NOTES:
 When using the BA option (Base Address), all four digits must be specified.
(Example: for COM 1 - /BA03F8)
 Use the /BA switch only when the serial port is located at a non-standard address
within the computer.
 A summary of command line switches are always available by starting the program
with switch /? or /H.
Example
To configure a tablet on COM 2 for MM/SummaSketch format, type: MM/2.