GTCO MM II 1201 - Users Guide - Manual (Page 10)

MM II 10
The clips attach to rails on the tablet underside. To attach them, push them straight on or
slide them up from the bottom.
Position the clips where they’re comfortably out of the way. To remove the clips, slide
them to the bottom of the tablet.
Chapter 3: Interfacing with the Host
For successful communication between MM II and its host, they must have the same
hardware interface, baud rate, communications protocol and report format.
Section A: Hardware Interface
The hardware interface consists of one cable terminated with a 25-pin male D connector.
(If the computer requires a different connector, contact your GTCO CalComp by Turning
Technologies representative for information about adapters.)