GTCO MM II 1201 - Users Guide - Manual (Page 33)

MM II 33
The configuration report does not express the resolution in lines per inch or lines per
millimeter. Rather, the resolution is expressed as the total number of counts over the
length of the axis.
Example: Resolution setting is 200 lpi. The X and Y axes are 11.7 inches long. Therefore,
the resolution is 2340 for each axis. The Send Configuration report is:
Tablet Identifier
Use this command to set a bit in the binary report format to a one or a zero. This can be
helpful in a dual-tablet configuration to distinguish between the reports coming from one
tablet versus the other.