GTCO MM II 1201 - Users Guide User Manual
Page 36
Advertising
MM II 36
Transducer identification: Command sends a character string to the host that
identifies which transducer (stylus or cursor) is attached to the tablet. The string is
one of the following:
CSR4<CR>
Four button cursor
CSR16<CR>
16-button cursor
STYLUS<CR>
Stylus
Section D: Reserved Commands
Do not use the ASCII commands zh, zd or zf or their equivalents. They are reserved for
factory use. If a reserved command is issued by mistake, clear it by repowering the tablet.
Advertising