GTCO MM II 1201 - Users Guide - Manual (Page 27)

MM II 27
Resolution, Definable (Set X, Y Scale)
Command Sequence: <command><X low byte><X high byte><Y low byte><Y high byte>
The purpose of the Definable Resolution function is to let you match the tablet resolution
to the resolution of another two-dimensional device, e.g. a computer screen. With
Definable Resolution:
 Define the resolution of each tablet axis, independent of one another.
 Clarify the resolution to be any value from 1 to 508 lpi.
Here’s how to use Definable Resolution:
1. Determine the resolution that’s desired for the entire length of the (tablet) axis:
 If the other device’s resolution is expressed in “units per…”, such as 37 lines
per inch, multiply that number by the tablet axis length. Example: other
device’s resolution x length of tablet axis = desired axis resolution
37 lpi x 11.7 inches = 432.9 = rounded to 433 … is the desired axis resolution
 The other device may have a resolution expressed as the overall axis values,
such as 800 by 1024 pixels.