GTCO MM II 1201 - Users Guide - Manual (Page 55)

MM II 55
Reassembling the Tablet
1. Ensure that the printed circuit board has not shifted or lifted out of position. It
should be held gently in place by the two posts at the top edge.
2. Hold the bottom cover upside-down over the top cover. Slide the bottom edge of
the bottom cover into the top cover so that the tabs fit into the slots.
3. Snap the bottom cover down against the top cover. The bottom and side tabs
should be seated in the slots.
4. Replace the three cover screws. Gently tighten, but do not over tighten. Too much
pressure can strip the screw threads. Ensure that there is no gap between the top
and bottom covers.