Haltech IQ3 Data Logger Dash - Manual (Page 37)

IQ3 Data Logger Dash Installation Manual
37
Example Warning Setup
As noted in the previous section, the dash warning setup allows the user to trigger a warning
light based on one sensor channel or two sensor channels. In addition, a specific text warning
may be programmed to display, when the warning parameters are met.
In the example setup below, the dash warning was programmed as follows:
Warning Channel One: Oil Pressure below 30 PSI
Text Above Warning Channel One: OIL
Warning Channel Two: Engine RPM above 1000
Text Above Warning Channel Two: TACH
Text To Display When Warning Values Are Met: Oil P
When at least one programmed warning channel is activated, the warning text will alternate
between the warning channel data the normal display page data once a second.
To clear ALL active warning, enter a SHORT press on Programming Button 1. This will clear the
warnings until the warning channel goes out of warning and then back in to warning again.
Warning Text
Primary Warning Channel
Secondary Warning Channel
Warning Light
Primary Channel Text Secondary Channel Text