Haltech IQ3 Data Logger Dash - Manual (Page 8)

IQ3 Data Logger Dash Installation Manual
8
External Sensors
The IQ3 Logger Dash utilizes Racepak’s Vnet (canbus) sensor input. This design provides the
ability to transmit all sensor data through a single cable. This cable is connected to the 5 pin
Vnet port on the rear of the dash. No sensor wiring harness is required.
To add sensors, the customer simply measures from the IQ3 dash to the mounting location of
the sensor or sensors, and orders the appropriate length pre-terminated Vnet extension cable.
Vnet cables are available in 12” increments and are equipped with a male connector on one
end and a female connector on the opposite end. In the event sensors are mounted in multiple
location throughout the vehicle, simple measure between each sensor location and order the
necessary Vnet extension cables to connect all items to the main Vnet cable routed to the rear
of the dash.
Any Vnet sensor currently offered by Racepak may be utilized by the IQ3 Logger Dash. For a
complete listing of available sensors, visit our website located at
www.racepak.com or contact
the Racepak customer service department at 949-709-5555 for a catalog. Customer supplied
sensors may also be utilized. Racepak’s USM module (PN: 230-VM-USM) is a four sensor input
module, providing the ability to define each sensor input dependant sensor type.
Sensor
Sensor
Sensor
Vnet Cable