Haltech IQ3 Data Logger Dash - Manual (Page 71)

IQ3 Data Logger Dash Installation Manual
71
Reference and Main Settings for Runlog Data Comparison
Insure at least two Lapfiles are open. To assign the Reference and Main status to two laps, in
order to provide comparison data with the Runlog pages:
1. Select any open lap as the Reference by placing the mouse cursor over the desired Lapfile
tab clicking the center button on the mouse.
If you are not using a three button mouse, it
will be necessary to go to the File Command in the Main
Menu and select the Set Reference File / File command.
This action will turn the Lapfile tab
red .
2. Select any second lap as the Main file by placing the cursor over any other desired Lapfile
Tab (other than the just selected Reference file) and left clicking.
Now, look again at the min, max and average data located below the track map on the Lap
Zoom Runlog page. The above action should activate the comparison between Lap 1 and Lap 3.
There is no set method for selecting Reference / Main files. It is at the users’ discretion to
determine which files will receive the Reference and Main settings. Either selection can be
assigned to any open file, by using the above instructions. The only item that must be
remembered is to always select the Reference file first, then the Main file second.
While it is not necessary to select Main and Reference settings to graph and view data, it is
necessary to perform the above actions in order to compare data in the Runlog pages.