Interlogix NX-4 - Manual (Page 22)

NX-4 Control
Page 20
AUXILIARY OUTPUT EVENT SELECTION
DATA EVENT DATA EVENT
0 /
Burglary Alarm
26
Fire Trouble
1 /
Fire Alarm
27
Chime
2 /
24 Hour Alarm
28 /
Expander Trouble
3 /
Trouble Alarm
29
Dynamic Battery Test Time
4 /
Tamper Alarm
30
Open Period
5
Yelping Siren (Burglary)
31
Closed Period
6
Temporal Siren (Fire)
32
Listen-In
7
Any Siren
33
Line Seizure
8
Any Bypass
34
Ground Start
9
AC Fail
35
Fail To Communicate
10
Low Battery
36
Reserved
11 /
Duress
37
Program Mode
12 /
Aux 1 Keypad Zone
38
Download In Process
13 /
Aux 2 Keypad Zone
39
Reserved
14 /
Panic Keypad Zone
40
Short Circuit (Over-current)
15
Keypad Tamper
41
Box Tamper
16 /
Autotest
42
Siren Tamper
17
Alarm Memory
43
Any Open
18
Entry
44
Any Short
19
Exit
45
Any Fault (Open/ Short on Non-Fire Zone)
20
Entry or Exit
46 /
Any Alarm
21
Armed State
47
Beeping Keypad
22
Disarmed State
48 /
Code Entry (See note below)
23
Ready
49 ˜ /
Key FOB Function 1
24
Not Ready
50 ˜ /
Key FOB Function 2
25
Fire
Notes: When Event 48 is programmed, it is possible to program a user code's authorization to select which output(s)
a particular code will activate. When LED 8 is on for an authorization, then LEDs 1- 2 correspond to that code
activating outputs 1 & 2 respectively. (See programming the LED keypads on page 8.)
˜ Events 49 & 50 require NX-408E, NX-416E or NX-448E wireless receivers to operate.
/ If set to follow condition, these events will be 1 second.
LOCATION 51 - AUTOTEST CONTROL (4 segments, numerical data)
Segment 1:
Program a "1" if the interval is to be in hours; Program a "0" if in days. Add a A2" to suppress the
daily test or a A3" to suppress the hourly test if any report has been sent.
Segment 2:
Program the Autotest interval from 1-255 hours/days.
Segment 3:
Program the Autotest report hour in 24-hour format (if the interval is in hours, this segment is
ignored).
Segment 4:
Program the Autotest report time, number of minutes after the hour.