Interlogix NX-4 User Manual

Page 6

Advertising
background image

NX-4 Control


Page 4

Built In Siren Driver


The NX-4 has a built-in 112db siren driver. When desired, this built-in driver can be easily converted to a 1 amp
voltage output through programming. (Loc. 37, page 17)

Bypass Toggle


This feature will enable the end user to toggle (turn on or off) the bypass of an interior zone with the system armed
by pressing the [Bypass] key. (Loc. 23, page 16)

Call Back


When enabled, the control will use the call back phone number to call the download computer before beginning a
download. (Loc. 21, page 16)

Cancel


If enabled, the NX-4 will send a "Cancel" report if when the system is disarmed and the [Cancel] button is pressed
within 5 minutes of an alarm. Once the [Cancel] key is pressed, the "Cancel" LED will illuminate until the central
station acknowledges the "Cancel" report.

ADialer Delay@ must be enabled in the ACharacteristic Select@ of Loc. 110-

149. (Loc. 23, page 16)

Code Required Options


The NX-4 can be programmed to require a code for bypassing zones and/or initiating a download using the [

r]-[9]-

[8] or [

r]-[9]-[9] function. (Loc. 23 and 41, pages 16 and 19)


Communication Formats


The NX-4 can report in multiple formats. It is recommended that you use Contact ID or SIA formats if possible. If
you wish to report to a pager or in a 4+2 format to a central station, you must program each code to be reported.
(Loc. 56-83 and 111-149, pages 22-25)

Configuration Groups


The NX-4 has 20 programmable configuration groups that determine how each zone will function and report. The
default configuration groups (Zone Types) are listed on page 25. (Loc. 111-149, pages 24-25)

Cross Zoning


This feature requires two or more trips on a zone or zones programmed as "cross zones" within a specified time
before reporting an alarm. During the time between trips, the NX-4 can be programmed to sound the keypad
and/or the siren. The NX-4 can also be programmed to report an alarm after two or more trips on the same zone.
(Loc. 37, 39, 40 and 110-149, pages 17 - 18, 24 - 25)

Dual / Split / Multiple Reports


The NX-4 can send communication reports to three different phone numbers for dual, split or multiple reports
selectable by event. (Loc. 4, 10, and 16, pages 13-15)

Duress Code


If a duress code is programmed, the NX-4 will send a duress signal whenever the panel is armed or disarmed with
this code. If open/close reports are sent, the user code will be 254. (Loc. 44, page 19)

Dynamic Battery Test


The NX-4 can be programmed to perform a Dynamic Battery Test for a selected duration the first time the panel is
armed or disarmed every day, as well as by pressing [

t][4] Test Function. The NX-4 can also be programmed to

perform a missing battery test every 12 seconds. (Loc. 37 and 40, pages 17 and 18)

Entry-Guard


This unique low level arming mode has been developed to reduce the most common source of false alarms. When
armed with the Instant light on, the opening of any zones designated as "Entry Guard zone" will initiate the keypad
sounder and start the entry delay before creating an alarm. All other zones will function as normal. This arming
mode will encourage system owners to use their system more frequently when the premise is occupied. (Loc. 111-
149, pages 24-25 NOTE: For UL installations, this feature shall be disabled.)

Advertising