Interlogix NX-8E Installation Manual - Manual (Page 50)

Chapter 2: Reporting codes
46 NX-8E Control Panel Installation Manual
Locations 88
Partition 1 account code Location 88 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account codes is six digits long, program
all six segments.
Location 89
Partition 2 account code Location 89 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account code is six digits long, program
all six segments.
Location 90
Partition 2 feature and reporting
selection Location 90 has five segments of feature selection data.
Use this location to enable certain features that are
accessed or visible to the user from the system keypad.
In addition, certain communicator reports are enabled at
this location. Each of these features can be enabled by
partition (Location 23).
Location 91
Partition 2 entry and exit times Location 91 has six segments of numerical data. Use
this location to program the entry/exit times for partition
2. There are two separate entry/exit times (Location
24).
Location 92
Partition 3 account code Location 92 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account code is six digits long, program
all six segments.
Location 93
Partition 3 feature and reporting
selection Location 93 has five segments of feature selection data.
Use this location to enable certain features that are
accessed or visible to the user from the system keypad.
In addition, certain communicator reports are enabled at
this location. Each of these features can be enabled by
partition (Location 23).
Location 94
Partition 3 entry and exit times Location 94 has six segments of numerical data. Use
this location to program the entry/exit times for partition
3. There are two separate entry/exit times (Location
24).
Location 95
Partition 4 account code Location 95 has six segments of numerical data. If the
account code is less than six digits, program a 10 in the
segment immediately after the last digit of the account
number. If the account code is six digits long, program
all six segments.
Location 96
Partition 4 feature and reporting
selection Location 96 has five segments of feature selection data.
Use this location to enable certain features that are
accessed or visible to the user from the system keypad.
In addition, certain communicator reports are enabled at
this location. Each of these features can be enabled by
partition (Location 23).
Location 97
Partition 4 entry and exit times Location 97 has six segments of numerical data. Use
this location to program the entry/exit times for partition
4. There are two separate entry/exit times (Location
24).