Interlogix NX-8E Installation Manual - Manual (Page 62)

Chapter 2: Reporting codes
58 NX-8E Control Panel Installation Manual
Location 212 - LCD keypad address
Location 212 has one segment of numerical data.
Certain commands in the NX-8E require it to know the location of at least one
LCD keyupad (if one exists in the system). If your system has an LCD keypad,
we recommend that you place it in partition 1 keypad 1. This will allow Location
212 to be left at the factory default. If the LCD keypad is selected as something
other than parition 1/keypad 1, program the appropriate address in Location 212.
Table 10: LCD keypad addresses
Keypad Partition number
1 2 3 4 5 6 7 8
1 192 193 194 195 196 197 198 199
2 200 201 202 203 204 205 206 207
3 208 109 210 211 212 213 214 215
4 216 217 218 219 220 221 222 223
5 224 225 226 227 228 229 230 231
6 232 233 234 235 236 237 238 239
7 240 241 242 243 244 245 246 247
8 248 249 250 251 252 253 254 255