Interlogix NX-8E Installation Manual - Manual (Page 53)

Chapter 2: Reporting codes
NX-8E Control Panel Installation Manual 49
Segment 2
1. On if zone type beeps the keypad for alarm.
2. On if zone type sounds the yelping siren for alarm.
3. On if zone type sounds the temporal siren for alarm.
4. On if zone type chimes.
5. On if zone type is bypassable.
6. On if zone type is included in the group shunt.
7. On if zone type is force armable.
8. On if zone type is entry guard (see Glossary)
Segment 3
1. On enables fast loop response (50 mS; off = 500 mS).
2. On enables double end of line tamper zone (mainly used to enable the tamper on wireless
zone.)
3. On enables trouble reporting zone (day zones and fire zones).
4. On if zone type is cross zoned.
5. On enables dialer delay zone (see Location 40).
6. On if zone type is swinger shutdown (see Location 38).
7. On enables restore reporting.
8. On enables listen in (see Location 40).
Segment 4
1. Enables zone activity monitor (see Location 40).
2. On enables end-of-line resistor defeat on zones that are not fire or keyswitch zones.
3. On enables zone to act as request to exit input/disables for alarm activation.
4. On enables zone to act as access entry point. Do not enable this segment unless configured
with access control.
5 to 8. Reserved.
Segment 5 - Reserved
Note: If dialer delay (Segment 3 Option 5) is turned off, the panel will not send cancel reports
even if enabled in Location 23.
Table 9: Locations 110 to 169
Location Zone
type
Description Default
110 1 Alarm code 8
111 1 Feature selection 0, 125, 35678, 0, 0
112 2 Alarm code 2
113 2 Feature selection 2, 125, 78, 0, 0
114 3 Alarm code 7
115 3 Feature selection 5, 1245, 5678, 0, 0
116 4 Alarm code 5
117 4 Feature selection 45, 125, 5678, 0, 0
118 5 Alarm code 5
119 5 Feature selection 457, 125, 5678, 0, 0