Juniper Systems Archer 2 User Guide - Manual (Page 10)

6 Archer 2 Rugged Handheld Owner’s Manual
Attach the Stylus Tether
A capacitive stylus and tether are included with the
handheld.
Note: A stylus is not required to use the touchscreen. The
optimal way to make selections is by finger touch.
One end of the tether is attached to the stylus. To attach it
to the hand strap, follow these steps:
1. Pull the free tether loop through the tether ring on the
hand strap. Insert the stylus with the attached tether
through this loop and tighten the loop.
2. Place the stylus into the holder on the hand strap.
Perform Set Up
1. The handheld powers on and begins the startup
process. A splash screen is shown that includes a
progress indicator at the bottom of the screen.
2. A Microsoft ® Windows Embedded Handheld screen is
shown.
3. The Clock and Alarms control panel appears. Adjust the
time zone, date and time if necessary and tap OK.