Juniper Systems Archer 2 User Guide - Manual (Page 81)

Ch 8 3G Data Modem 77
3. Remove the battery pack.
CAUTION: The Archer 2 is not sealed against water and
dust when the battery door is not installed.
4. An image on the battery compartment label shows the
correct location and orientation for the mini SIM card.
Pull out the SIM card tray. Place the card onto the tray
and push the tray in until it catches.
To remove the SIM card, pull the tray open and remove
the card. Push the empty tray in until it catches.
5. Replace the battery pack, and attach the battery door.
6. Power on the Archer 2.
Note: If the modem was on before shutting the Archer
2 down to insert the SIM card, you are prompted to
configure the data connection when you reboot. See
the instructions on the following pages.
!