Juniper Systems Archer 2 User Guide - Manual (Page 89)

Ch 9 Barcode Scanner 85
Barcode Setup
When you select Barcode Setup, The Barcode Connector
control panel is displayed. Near the top of the screen is a
horizontal scrolling menu. Select screens from the menu to
view or edit the configurations for the Barcode Connector
utility and the barcode hardware. A description of these
screens follows.
User Screen
The User screen has the following functions:
„
Button Control Panel – The target button is the scan
button by default. You can change this to another
programmable button from the Button control panel.
Select the hyperlink to view that screen.
„
Trigger Mode While Holding Scan Button – Select Scan to
start scanning the moment the button is pressed. Select
Aim to turn on the aimer when the button is pressed and
to start scanning when the button is released.
„
Beep On and Visual On – Select options for audio and
visual indicators based on good or bad scan reads.