Fcc regulations, Fcc-1 – Canon BJC-5100 User Manual
Bubble Jet Printer Model K10902
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
❍ Reorient or relocate the receiving antenna.
❍ Increase the separation between the equipment and receiver.
❍ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
❍ Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply with Class B limits in
Subpart B of Part 15 of the FCC Rules.
Do not make any changes or modifications to the equipment unless
otherwise specified in the manual. If such changes or modifications
should be made, you could be required to stop operation of the
Canon Computer Systems, Inc.
2995 Redhill Ave.
Costa Mesa, CA 92626