Keri Systems BioPointe Users Manual - Manual (Page 12)

Getting Started
11
Steps for Applying Power
Step 1: Ensure that the power adapter is powered off.
Step 2: Insert the two wires of the power adapter correctly into the connector.
Step 3: Switch on the power to the adapter.
When the device is powered on, all three LEDs will be blinking continuously in red color.
When the device is ready, the first LED will turn to steady amber color while the second and third
will be turned off. However, if the first LED is blinking periodically in red color instead of being
steady amber, it is likely that the tamper switch is opened.
If you want the first LED to stop blinking in red attach the C-bracket so that the tamper switch is set,
or disable the alarm through the device settings (see Chapter 4 – Administering the BioPointe).
Pin Description
1 GND
2 DC 12 to 24V
1 2 3 4 5 6 7 8 9 10 11 12
Inserting the cable:
1)
Use a test-pen to push
in the spring lever.
2) Insert cable into hole.
3) Release spring lever.
4) To ensure cable is
secure, pull it slightly.
Make sure it is seated
tightly and does not
come out.
Spring lever