Keri Systems BioPointe Users Manual - Manual (Page 43)

Administering the BioPointe
42
4.5.3 Changing the Security Level
The following steps describe how the Security Level in the BioPointe can be set. The allowed levels are
Normal and High. By default, the security level of the device is at the Normal level.
Note that this security level pertains to using one-to-one matching (verification) as opposed to using one-to-
many matching (identification). Configuring of the security level used in one-to-many matching is not
allowed. It is defaulted to a high level.
Steps LED and Buzzer Status
Press , , .
The LEDs will light up as shown in 1. The sensor
will also light up, waiting for a master fingerprint
to be verified.
Place the master finger on the sensor to
verify.
a) If the finger is successfully verified as a
master, the 1
st LED will blink green briefly as
shown in 2(a). The 2 nd LED will blink slowly in
green next while the 3 rd LED is steady red.
Proceed to step 3.
b) If the finger is not successfully verified as a
master, the 1
st LED will blink red briefly as
shown in 2(b). Operation will cease and return to
normal mode.
Press or , the number that
corresponds to the appropriate mode,
followed by to confirm.
Or,
Press to exit.
1 corresponds to the Normal level, while
2 corresponds to the High level.
When the mode has been successfully set, the 1 st
LED will blink green briefly as shown in 3.
1
1
AMBER RED
3
GREEN
→AMBER
GREEN
2b
RED
→AMBER
Master verification fails
RED
2
2a
3
GREEN
→AMBER
1
#
*
3
2