Keri Systems BioPointe Users Manual - Manual (Page 42)

Administering the BioPointe
41
4.5.2 Enabling or Disabling the Fingerprint Identify Mode
The following steps describe how the Fingerprint Identify Mode in the BioPointe can be set. To find out
more on this feature, you can refer to the section on "Fingerprint Authentication" in Chapter 3.1.1.
Steps LED and Buzzer Status
Press , , .
The LEDs will light up as shown in 1. The sensor
will also light up, waiting for a master fingerprint
to be verified.
Place the master finger on the sensor to
verify.
a) If the finger is successfully verified as a
master, the 1
st LED will blink green briefly as
shown in 2(a). The 2 nd LED will blink slowly in
green next while the 3 rd LED is steady green.
Proceed to step 3.
b) If the finger is not successfully verified as a
master, the 1
st LED will blink red briefly as
shown in 2(b). Operation will cease and return to
normal mode.
Press or , the number that
corresponds to the appropriate mode,
followed by to confirm.
Or,
Press to exit.
0 corresponds to Disable, while
1 corresponds to the Enable level.
When the mode has been successfully set, the 1 st
LED will blink green briefly as shown in 3.
1 1
AMBER RED
2
2a
GREEN
→AMBER
GREEN
2b
RED
→AMBER
Master verification fails
3
3
GREEN
→AMBER
GREEN
2
1
#
*
0