Keri Systems BioPointe Users Manual - Manual (Page 48)

Performing Authentication with the BioPointe
47
One-to-One Matching using the Card Reader
Flash your card across the device.
(Your card ID must be the same as the UserID enrolled previously.)
If the ID exists, the sensor will light up and the 2
nd LED will blink fast in red.
Place your finger on the sensor, removing it only when the sensor light goes off.
If the 1
st LED lights up in green, the authentication is successful.
If the 1
st LED lights up in red, you will be allowed another try. Place your finger on the
sensor again when it lights up.
2
1
3